产品分类
联系我们
回收CISCO NM PA系列
首页 » 产品展示 » 网络模块接口卡回收 » 回收CISCO NM PA系列
PA-POS-2OC3思科原装线卡模块
发布时间:2013/12/4 15:20:46 点击量:
PA-POS-2OC3产品简介
You need the following PA-POS-2OC3思科原装线卡模块tools and parts to install a PA-POS-2OC3. If you need additional equipment, contact a service representative for ordering information.PA-POS-2OC3思科原装线卡模块•PA-POS-2OC3
•Cisco 7200 VXR routers Port PA-POS-2OC3思科原装线卡模块Adapter Jacket Card for installation of a port adapter in the I/O controller slot (requires an NPE-G1)
•Cisco 7304 PCI port adapter carrier card for installation in a Cisco 7304 router
•VIP motherboard (40, 60, 80) for installation PA-POS-2OC3思科原装线卡模块in Cisco 7500 series modules
•FlexWAN module for installation in Cisco 7600 series modules
•One LC-type duplex or two LC-type simplex, PA-POS-2OC3思科原装线卡模块multimode, or single-mode optical fiber cables per port to connect the interface with the network. (Single-mode and PA-POS-2OC3思科原装线卡模块multimode optical fiber cables for the PA-POS-2OC3 are not available from Cisco Systems but are available from commercial cable vendors. For information about optical fiber cables, see the "OC-3 Optical Fiber Specifications" section on page 1-4 and the "Cables and Connectors" section on page 1-6.)PA-POS-2OC3思科原装线卡模块
•Number 1 Phillips screwdriver
•Number 2 Phillips screwdriver
•Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares
•Antistatic mat
上一条:PA-T3思科原装线卡模块 | 下一条:PA-MCX-8TE1思科原装线卡模块